License & Backup
- 7" Incandescent 1013 Series Backup Lamp
• DOT Approved
• Diameter 7in(178mm) Depth 1.69in(43.0 mm)
• Volts 10-16VDC 4.5 Watts 0.38 ampsOut of stock - 3" Compartment/Utility Dome Lamp-CLEAR
• Ground wire option for non-metallic mount - Buyers 4" 10-LED Round Backup Light
• Clear lens, uses a standard PL-2 connection
• Recess mount, plug and grommet includedHeavy Duty Truck/Equipment
Snow Plow Lights, Trailer Lights
Construction, Landscape, Utility -
PETERSON LED LICENSE LIGHT
• 4 Diodes, 9-16 Volt Operating Range
• Includes Light And Mounting Gasket
• Requires 2 Lights To Meet DOT Regulations -
MAXXIMA 4" ROUND BACK-UP LIGHT WITH REFLECTOR - WHITE
• 12.8vdc, Amp Draw: 200ma
• Dry Fit Connector - 4” 10 LED Sealed Clear DOT Back-Up Light
• Recess Mount, Sonically sealed, waterproof
• Certified for back-up light function when installed as pair in two-lamp system
• Accept standard - FA Series 7" Round Backup/Reverse Light-Clear
• Reinforced stainless steel screw bosses
• Weatherproof seal with adhered neoprene gasket
• Includes 7”?? wire lengthHD TRUCK/BUS/POLICE/FIRE/EMSOut of stock - SuperNova NexGen 4" Dual-System LED Backup Lights
• Two-lamp system meets all back-up function requirements
• Hard coated lens for long-term UV protection
Environmental encapsulant potting for total circuit board -
TRUCK-LITE SUPER 44 LED DOME LIGHT - WHITE/CLEAR
• 12V Round Hardwired, .180 Bullet, Gray Flange Mount
• Polycarbonate Lens And Housing -
TRUCK-LITE SUPER 44 LED BACK-UP LIGHT - WHITE/CLEAR
• 12V Fit 'n Forget S.S., Gray Flange Mount
• Polycarbonate Lens And Housing - 4-1/4" 6 Diode LED Submersible Backup Light-CLEAR
• Sonically Ssealed, Waterproof Housing and Lens
• Recessed mount with grommet
• Dimensions: 4-1/4" diameter x 1-5/8" deep
• Power draw - LED Courtesy Stepwell Light-CLEAR
• Stainless Steel/Polycarbonate
• Same mounting as popular incandescent versions
• Connections can be easily adjusted for typical installations
• Designed for bus electronics, seamless integrationOut of stock - Stainless Steel Recessed Dual System Backup Light
• Snap-in lens for easy replacement
• Requires two lamps to meet backup function - 4" Backup/Utility Lamp Black Bezel
• Polycarbonate lens
• Black ABS trim ringOut of stock - Stainless Steel Courtesy Lamp
• Illuminates instrument panel and compartments
• Clear plastic lens -
TRUCK-LITE 17 SERIES LICENSE LIGHT - CLEAR
• Single Incandescent Bulb 12V, Bullet Plug
• Horizontal Mount Only -
TRUCK-LITE LED SUPER 44 BACK/UP LIGHT - WHITE/CLEAR
• 12V Round, Hardwired, Stripped End
• Black Flange Mount, Polycarbonate Lens And HousingOut of stock -
TRUCK-LITE SIGNAL-STAT LED BACK-UP LIGHT - CLEAR
• 12V Round, PL-2 Right-Angle Connection
• Polycarbonate Lens And Housing, Epoxy-Encapsulated Electronics -
TRUCK-LITE SUPER 44 LED BACK-UP LIGHT - CLEAR
• 12V Round, Sealed, Fit 'n Forget S.S.
• Polycarbonate Lens/Housing, Gray Flange Mount -
TRUCK-LITE SUPER 44 LED BACK-UP LIGHT - CLEAR
• 12V Fit 'n Forget S.S.
• Diamond Shell, Grommet Mount -
TRUCK-LITE SUPER 44 LED BACK-UP LIGHT - CLEAR
• 12V Round, Fit 'n Forget S.S.
• Diamond Shell, Gray Flange Mount -
PETERSON 4" 7 LED BACK-UP LIGHT-WHITE
• 9–16 volt operating range, Advanced optics fully illuminate lens
• Skirted weld joint for added protection against moisture - FA Series 4" Backup/Reverse Light Flange Mount
• Advanced Optical Technology Exceeds All FMVSS and SAE Requirements
• Specifically Engineering Optics to Boost Light Output and Brightness
• Sonic Welded,HD TRUCK/BUS/POLICE/FIRE/EMS - 4" Torsion Mount® II Dual-System Backup Lamp
• Female Pin
• Frosted Clear, Polycarbonate
• Requires two lamps to meet backup function
• Torsion Mount® II Gel-Mount® bulb cradle design
• Kit includes lamp, grommet -
GROTE SUPERNOVA 4" DUAL-SYSTEM LED BACKUP LAMP - 24 VOLT
• Requires two lamps to meet backup function
• Encapsulant potting for total circuit board protection