- Category
- Brackets & Grommets 181
- Clearance & Marker Lamps 627
- Forward / Work Lighting 109
- Hazard / Warning Lights 279
- Headlamp & Fog Lights 36
- Interior Lighting 62
- Lamps & Bulbs 271
- License & Backup 130
- Lighting Switches & Controls 21
- Mirrors & Brackets 45
- Pigtails, Sockets & Equalizers 183
- Reflectors & Safety 34
- Stop / Tail / Turn 503
- Trailer Light Kits & Accessories 25
Vehicle Lighting
-
MAXXIMA 3-PIN 90° PLUG-IN PIGTAIL FOR FEMALE-PIN LAMPS
• 100pc Continuous, Chassis Ground, Blunt Cut Wires
• Dual function for S / T / T lamps -
MAXXIMA 3-PIN LED LOAD EQUALIZER
• 12.8VDC, 3-Pin LED, 7" Lead
• Allows LED Use With Standard Flashers -
MAXXIMA DRY FIT STT CONNECTOR
• Connector For M42344r And M42348
• Drop-In Replacement To OEM Style Harnesses -
MAXXIMA HEADLIGHT LOAD EQUALIZER MODULE 36" LEAD FOR 4X6LL/LO/HI
• 24VDC, DC Voltage Converter
• For Use With 12V LEDs to 24V Vehicle -
MAXXIMA 4" ROUND RED STOP/TAIL/TURN SERIES - A
• 12.8vdc, Amp Draw 300ma / 20ma
• PL-3 Connector -
MAXXIMA 6" SNAP-ON FLANGE BEZEL – CHROME
• For The 60 Series
• High Impact Polycarbonate -
MAXXIMA 6" OVAL STOP/TAIL/TURN LIGHT - RED/CLEAR LENS
• 12.8 VDC, Amp Draw 140mA
• 3-Wire Connector 13" Leads, Nickel Plated Brass -
MAXXIMA 5" SURFACE MOUNT 9 LED 400 LUMEN LOAD LIGHT
• Polycarbonate Lens & Cast Aluminum Housing
• 40 degree downward light output -
GROTE 2 1/2" ROUND STICK-ON REFLECTOR-RED
• Adhesive backing protects prism against dirt
• Firm-stick backing for instant bond and lasting adhesion - Mounting Bracket 2" & 2 1/2" Round Lights
• Grommet required for mounting
• 2 1/4" mounting hole spacing
• Steel, Black EnamelOut of stock - Clearance Marker with Built-In Reflector-AMBER
• Corrosion-resistant body
• Flange mounting & built-in reflector
• Boat, snowmobile, trailer, and RV - SuperNova Flush-Mount LED Cab Marker Light
• Hermetic lens to housing seal
• Potted for total circuit board protection
• Sealed hard-wire terminations with UBS molded .180 bullet terminals
Freightliner, Sterling, Navistar Trucks - SuperNova® Sealed Turtleback® II LED Clearance / Marker Lamp / BUILT-IN REFLECTOR
• Red, Polycarbonate (Optic) / Acrylic (Reflex)
• Encapsulant potting for total circuit-board protection
• Hermetic lens-to-housing seal
• Tin-plated, solid-brass terminalsOut of stock - 24V SuperNova 2" LED Clearance Marker Light
• RED-Hermetic lens-to-housing seal
• Encapsulant potting for total circuit board protection
• Tin-plated, solid-brass terminals are sealed to housing, to resist corrosion - MicroNova Dot LED Clearance Marker Light-RED
• No fasteners required
• Sleek aerodynamic styling extends less than 3/8" from mounted surface - SuperNova Oval LED Side Turn Marker Lights
• Stainless Steel Theft-Resistant Flange
• Male pin and hard shell connection options
• Flashing turn signal is visible to driver during operation45º Angled Beveled-Edge Mounting Grommet
• Fits 2 3/4" hole
• Fits all 2 1/2" round lamp
• Open back fits panel thickness up to 3/16"
• Closed back fitsBriteZone LED Work Light 775 Raw Lumens
• Hand Held EZ Grip comes with a wall charger
• Magnetic base allows you to secure the lamp to most metal surfacesSchool Bus Wedge LED Marker Light-RED
• Potted circuit board
• Mounting gasket included
• Blunt-cut, hardwire termination
• Hermetically sealed construction
• 15 Diodes in both red and amber6" Grommet Oval Lights
• Fits 2 1/2" x 6 3/4" oval hole
• Fits panel thickness up to 1/4"GROTE LICENSE & UTILITY SOCKET ASSEMBLY
• 1 Wire 18 Guage 12" Long
• For use with 63, 67, 81, 89, 97, 1003, 1141, 1156 bulbs4-WIRE Plug Assembly 2351 Series
• Weather Pack Moisture Resistant
Out of stock7" LED Stop/Turn/Tail Round Black Base-Red
• Upgradeable Single V-LED design
• Dual lens seal protects circuitry should exterior lens be damaged
• Low power consumption/amperage draw
• Diameter 7in(1785" Recess Mount Back-Up Lamp-Clear
• Corrsion resistant, Four screw mount
• Meets DOT backup lamp requirementsOut of stock4" Cab Marker 2 Wire-Red
• With Shield Use 5120-1300-10Out of stockCab Marker W/Shield 2 Bulb/2 Wire-Red
• 5.25" x 4.68" Chrome Plated ShieldCab Marker W/Shield 2 Bulb/2 Wire-Amber
• 5.25" x 4.68" Chrome Plated Shield7" Compartment/Utility Dome Lamp-CLEAR
• Flush Mount, 6.91" X 3.12"Out of stock3" LED License Lamp-Clear
• Surface mount w/delphi connector
• Damage resistant housing and lensOut of stock4" LED Stainless Steel Turn/Marker-Amber
• No rust or corrosion issues
• Durable Polycarbonate LensOut of stock